Bottlehead Forum Bottlehead Forum
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Now taking orders for the Tode, Bottlehead's new guitar amp kit!
 
   Home   Help Search Calendar Login Register  
Bottlehead Forum > General Category > Technical topics > OB2/OB2WA equivalents
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: OB2/OB2WA equivalents  (Read 683 times)
0 Members and 2 Guests are viewing this topic.
Maxwell_E
Full Member
***
Offline Offline

Posts: 131


Max Tomlinson


View Profile
« on: November 23, 2010, 09:55:26 AM »
I'm trying to test some OB2 tubes at work on a Hickok 6000A tester. The problem is they don't have settings for these tubes, and a 30 minutes of googling hasn't shown any viable test settings, or even equivalent tubes that may be in the charts. Can anybody help?
Logged
Doc B.
Administrator
Hero Member
*****
Offline Offline

Posts: 1858



View Profile WWW
« Reply #1 on: November 23, 2010, 10:16:17 AM »
Hey Max,

Do you have a specific piece of gear they fit in? If so, try them in there. If they strike and glow and the voltage at the plate pin (pin 1 or pin 5) runs at around 108V they are good. If they don't strike make sure the power supply feeding the tube is at least 130V and they are getting hit with a bit of light.
Logged
Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.
Maxwell_E
Full Member
***
Offline Offline

Posts: 131


Max Tomlinson


View Profile
« Reply #2 on: November 23, 2010, 02:36:48 PM »
Yea, I finally found the original service manual and they gave an in-circuit test for them. Thanks.
Logged
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.10 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!