First Project Tool Suggestions

[Grainger49]

Here is a hand full of tools I took a picture of.  The pen of the soldering station is being held by the $3 Harbor Freight Third Hand.  

Across the top are solder, diagonal cutting pliers, needle nose pliers & nippers (for clipping leads).

The bottom row is my Fluke meter, Weller soldering station and the third hand.

The second picture is a close up of the third hand.

[james93]

Grainger,

  Thanks for putting the time in to keep this post updated, and to everyone that added information.

  This is my first post, I just joined since I ordered a Crack and Speedball.  I have seen and heard about the Bottlehead products from the speaker world but never purachsed any.  Now getting into the headphone world I decided to give the DIY a try.  It will be my first DIY project and reading thru this site and the Head-Fi site is really helping.

  I went to the site that Doc mentions in your first post and I'm going with the items he mentions.  I don't know if I'll be doing to many DIY projects so I'm just getting the basic things.  I did find a good looking third hand with magnifier so I'll pick that up also.

Thanks again everyone,
James

[4krow]

Maybe I missed it, but I use a tool that is non conventional, and I wouldn't trade it for any wire cutter when it comes to trimming wire leads on a pc board. Nail clippers    yup, they are perfect! Just don't tell my wife.

[Laudanum]

Maybe I missed it, but I use a tool that is non conventional, and I wouldn't trade it for any wire cutter when it comes to trimming wire leads on a pc board. Nail clippers    yup, they are perfect! Just don't tell my wife.

I do the same thing.  They get dull quicker but I just buy a couple of the 98 cent clippers at wallyworld so I have them.  Toss when too dull.   I've also used them for as long back as I can remember for cutting the extra line when tying fishing knots or making up monofilament leaders.  Never did like using my teeth for that.  They work great for trimming you nails too :-P

[4krow]

Cutting nails too? Then it's a no-brainer!
  I know that it has been mentioned here before about the quality of tools and how they might affect your job. But it bears repeating, because I just used a Rat Shack soldering pencil last night on a project and the heat was not steady. After ruining a couple of circuit traces, I switched to a Weller. The difference is the difference between a good job, or instead, a few tears. In this case, tears won. Yah, a certain quality of tool matters.